Sample frequency conversion

From LavryEngineering
Revision as of 19:21, 26 February 2012 by Brad Johnson (Talk | contribs)
Jump to: navigation, search


The term "Sample frequency conversion" is interchangeably with the term Sample rate conversion and their abbreviations SFC and SRC. These terms are used to describe a process which employs DSP to re-sample a digital audio signal input at its original sample frequency and output it at a different sample frequency.


The need for high quality sample frequency conversion in digital audio came about in part due to the lack of a single standard for the sample frequency use by early digital audio recording systems. Prior to SONY/Phillips announcement of the CD standard of 44.1 kHz, each manufacturer used a different sample rate for their pioneering systems. Due to the need for standardization; professional audio manufacturers settled on the earliest standards of 44.1 and 48 kHz. The 44.1 kHz standard was chosen for obvious reasons; if the main form of distribution for consumers was to be the CD; systems had to be available to generate the needed digital audio recordings.

But professional audio manufacturers were also concerned about the limitations of the "barely adequate" choice of 44.1 kHz for a number of reasons; including the severe restrictions it placed on the design of filters necessary both in the AD converter inputs and DA converter outputs. A SF of 44.1 kHz implies a Nyquist frequency of 22.05kHz and thus required filters with a very "steep cut-off" to be employed to allow inputs up to 20kHz to pass at full level and provide sufficient attenuation of 90-100dB at 22.05 kHz. The practical of "vari-speeding" the recording to allow musicians to sing or play in a more comfortable range than the track was to be played would have introduced problems with a sample frequency of 44.1 kHz when the sample rate was reduced below 44.1 kHz during the vari-speed operation because the filters would no longer remove signals below the Nyquist frequency (one-half the SF), resulting in alias-frequencies being generated. Filter requirements were also eased compared to 44.1 KHz and the early implimentation of the required filters with very steep cut-offs quite often resulted in audible side-effects in the audio frequency range.

Additionally; early digital video systems adopted 48 kHz as their standard SF which increased the need to convert digital recording made at 44.12 kHz to 48 kHz and vice-versa.

Largely due to the lack of high quality digital processing that performed tasks common to Mastering such as equalization and compression/limiting; the need for high-quality sample rate conversion was often addressed simply by playing the original recording back through a DA converter for analog processing and re-encoding using an AD converter operating at the desired SF.

As the pursuit of quality continued in digital audio; higher sample frequencies equal to twice the original standards of 44.1 and 48 kHz were introduced. Using SF's that were exactly twice or one-half the output SF makes the used of synchronous sample frequency conversion possible; with the resulting increased accuracy and reduced computational demands. Changes in the method used for conversion with the introduction of over-sampling converters also meant that conversion could occur at higher SF's than the output (AD) sample frequency or input (DA) sample frequency. By converting at frequencies higher than 44.1 or 48 kHz; filter design constrains were eased significantly, allowing filters with higher cut-off frequencies and thus less-steep cut-off's to be used. This helped eliminate the source of many of the audible side-effects of steep cut-off analog filters used in the early converter designs.


Personal tools